Image Sub-Page

The IMAGE page is illustrated below:

It serves for:

1. Loading the input image if no image is defined in the Model Settings interface. The user has to manually select the Images tab and load an image using the Load button available on the lateral task bar as illustrated in the capture above.
2. Cropping: if the image field-of-view is too large the data set can be reduced in order to save RAM and optimize processing. This can be achieved enabling the Crop box. A yellow crop volume appears on the image. Place the yellow crop volume indication by clicking in the center of the area of interest such that is fully enclosed. The edge Size in [mm] can be adjusted for each direction by selecting the size in the corresponding list. The Crop button initiates cropping, whereby the original data are replaced. If cropping is not initiated manually, a request will be shown when proceeding to the Image VOI step.

Note: The cropping operation is only allowed once.

Action Buttons

After the input image(s) have been optionally cropped, processing can be moved on by activating the VOIs red action buttons. They will open the VOIs sub-page.